Ceiling Framing
Yeah! We're finally going to get started! So we will be getting started on removing the front skin tomorrow and hopefully get the roof ready to remove too. While I was on my Facebook, there was a...
View ArticleRe: Ceiling Framing
I can't comment on the use of 2x4, but I can on the grade of wood used. This wood should never have been use for a roof. Look at the knots running thru most every piece... If you take your time and...
View ArticleRe: Ceiling Framing
Sweets Personally I feel a 1x3 on its edge would be stronger than the 2x4 placed like this but what do I know LOL
View ArticleRe: Ceiling Framing
My ceiling originally had 2 x 2's, with two 1 x 2's running almost the full length of the roof to give it a little pitch. Since I went back with a roof top A/C unit, I needed a bit more strength. I...
View ArticleRe: Ceiling Framing
I suppose if the original dimesions were the same that is what I would do. Laying flat is not a big deal, my Loafer is framed with 1x2's on flat. I agree with the comments onthe knots thoigh. Small...
View ArticleRe: Ceiling Framing
I am sistering the 1x3 framing for the vent with 3/4" aluminum square stock that is about 1/8" thick... that should be strong enough!Bob
View Article
More Pages to Explore .....